How to Install the X-Ergo Rear Housing Assembly

By Stylecraft US | Published: 2026-10-30

Category: How-to Guides

Step-by-step guide to swapping the X-Ergo rear housing assembly, including motor and battery replacement, with common mistakes to avoid.

Quick answer

To install the X-Ergo rear housing assembly, remove the old rear housing, transfer the front housing lid and blades, then snap the new assembly into place. This guide walks you through each step and highlights common pitfalls.

Why replace the rear housing?

The rear housing of the X-Ergo clipper houses the motor and battery, which are the most common components to fail over time. Replacing the entire rear housing assembly is often faster and more reliable than sourcing individual parts, since the motor, battery, blade bracket, taper lever, and switch come pre-installed.

This replacement is a modular design, so you don't need to solder or rewire anything. However, you must transfer the front housing lid and blades from your existing clipper, as those are not included in the new assembly.

What's included and what's not

The X-Ergo replacement rear housing assembly includes the motor, battery, blade bracket, taper lever, and switch. It does not include the blades, blade spring, blade runner/cam follower, front housing lid, blade screws, or housing screws. Before starting, gather these parts from your existing clipper or have replacements ready.

Installation steps

Power off and remove the blade assembly: Ensure the clipper is off and unplugged. Remove the blade screws and lift off the blade assembly, including the blade spring and blade runner/cam follower. Store them safely. Check that the blade spring and runner are in good condition; replace them if worn.
Separate the front housing lid: The front housing lid is not part of the replacement assembly. Gently pry it off the old rear housing, being careful not to break the clips. Set it aside. Inspect the clips for cracks; a broken clip can cause the lid to fit loosely.
Detach the old rear housing: Remove the housing screws (not included in the new assembly) and carefully pull the rear housing away from the clipper. Disconnect any wiring harnesses if present, noting their positions. Keep track of screw lengths and locations; mixing them up can strip threads.
Install the new rear housing: Align the new rear housing with the clipper body and reconnect any wiring. Press it firmly into place, then insert and tighten the housing screws. Make sure the switch and taper lever align correctly with the openings before tightening.
Reattach the front housing lid: Snap the front housing lid onto the new rear housing, ensuring all clips engage securely. If the lid doesn't seat flush, check for misaligned clips or debris.
Reinstall the blade assembly: Place the blade spring, blade runner/cam follower, and blades back onto the blade bracket. Secure with the blade screws and adjust the taper lever as needed. Test the taper lever to ensure it moves freely before using the clipper.

Product facts

X-Ergo Clipper Replacement Rear Housing Assembly Motor/Battery: This replacement rear housing assembly includes motor, battery, blade bracket, taper lever, and switch, and fits the Gamma+ X-ERGO model. You get the core electronic and mechanical components in one unit, so you don't need to source them separately.
X-Ergo Clipper Replacement Rear Housing Assembly Motor/Battery