Missing Clipper Lid Screws? Absolute Alpha 3-Pack Fix Guide
By Stylecraft US | Published: 2026-11-01
Category: How-to Guides
Lost a lid screw on your Absolute Alpha clipper? Use this symptom-to-fix guide to diagnose the problem, replace it with the 3-pack, and know when to stop.
Quick answer
If a lid screw is missing from your Absolute Alpha clipper, replace it with the Replacement Absolute Alpha Hair Clipper Lid Screws 3-Pack rather than running the clipper with a loose or absent fastener. The 3-pack gives you the correct steel screws for the lid, plus spares for future loss.
Why a missing lid screw is more than a cosmetic issue
A lid screw holds the clipper housing together. When one goes missing, the lid can lift slightly, letting hair and dust into the internal cavity. That grit can interfere with the blade mechanism and make cleaning harder. The screw also keeps the lid aligned, so a missing fastener can cause a rattling noise or a loose feel in the hand.
The Absolute Alpha lid screws are specifically sized for that model. Using a random screw from a drawer risks stripping the threads in the housing, which is a much harder repair than replacing a screw. The 3-pack removes that temptation by giving you the right part and two spares.
When to stop and choose another option
Stop and do not force a new screw if the hole in the lid or housing is visibly cracked, if the threads inside the housing are stripped, or if the screw spins freely without tightening. In those cases, the problem is damage to the mounting point, not the screw itself. A replacement screw will not fix a cracked boss or stripped thread, and continuing to tighten can make the damage worse.
If the clipper has other faults—such as a blade that won't move or a charging issue—address those separately. This guide covers only the lid fastener. For charging problems, see our clipper charging guides; for blade issues, check the blade alignment before assuming the lid is at fault.
Diagnose and fix your missing lid screw
- Symptom: the lid lifts or rattles, and one screw hole is empty: Confirm the screw is actually missing by looking into the empty hole with a light. If you see a broken screw shaft still in the hole, stop—this is not a simple replacement. If the hole is clear, proceed to the corrective action.
- Likely cause: the screw worked loose over time or was lost during cleaning: Vibration from normal use can back a screw out gradually. If the remaining screws are also loose, tighten them gently—do not overtighten—before installing the new one. Check the lid for cracks around the screw holes; a cracked lid will not hold a screw securely.
- Corrective action: install a replacement screw from the 3-pack: Remove the lid if needed to access the hole. Start the new screw by hand, turning it counterclockwise until you feel it drop into the existing thread, then tighten clockwise until snug. Do not force it. The screw should hold the lid flush without a gap. Test by gently lifting the lid—it should not move. If the screw tightens but the lid still lifts, the lid or housing may be warped; stop and inspect further rather than adding force.
- When to stop: cracked housing, stripped threads, or a screw that won't tighten: If the screw spins freely, the internal threads are stripped. If you see cracks around the screw hole, the mounting point is damaged. In either case, a new screw will not fix the problem. Stop and consider whether the clipper is still safe to use—a loose lid can let debris in—or whether the housing needs professional attention.
Product facts
- Replacement Absolute Alpha Hair Clipper Lid Screws 3-Pack: The 3-pack contains high-quality steel screws designed to fasten the lid of the Absolute Alpha clipper. Steel screws resist stripping better than soft mystery screws, and having three means you can replace a lost one now and keep spares for later.
Replacement Absolute Alpha Hair Clipper Lid Screws 3-Pack
